Part 2 is relatively short as i only focussed on the sunroof and door for the sunroof all i did was first make side panel of the car. This is the part of the car is connected to the driver’s window, don’t know what you call it. Throughout the whole process i have been using polygon planes to model the car but for this part i will be using polygon cube so it will able to have some depth to where the window is. After the first cube was made all i did was extrude each time to make it reach the back side of the car, this is where the sunroof was then produced. Yet another extrusion was done but this time to the bring out the sunroof forward, i can’t really explain correctly but once you look at the image you will get an understanding of what im talking about :).
The door was created separately from polygon plane, and was the most tricky to do. It was easy modelling th door but when you take a look at the actual car you can see that the middle of the door slightly curves inwards. The reason this was tricky was because i did not have enough faces and vertices to modify to produce the smooth inwards curve, and my topology was not all that good on the door so i had to start again but this time taking in how many vertices i need into consideration. After finally spending a long time on adjusting the door it looks good to me so now i can move on, here are the first stages of the door
No comments:
Post a Comment